Product Introduction

Model Interpretation

• 45C = Family code for Reliance Electric Shark XL / AutoMax series system modules.

• 922 = Power supply module; “9” denotes system power, “22” denotes 115/230 VAC dual‑range input type.

• No suffix indicates standard revision; functionally fixed within the Shark XL line.

Technical Parameters

• Input voltage: Jumper‑selectable 115 VAC or 230 VAC (100–240 VAC range).

• Input frequency: 50/60 Hz.

• Output: Regulated DC for backplane; typical 24 VDC / 0.25 A or system‑specific DC rails.

• Max output current: System‑rated up to 16 A (backplane total).

• Protection: Overvoltage, overcurrent, short‑circuit, thermal shutdown.

• Isolation: Input‑to‑output galvanic isolation.

• Indicators: Power OK LED, fault LED (overvoltage/overcurrent/thermal).

• Operating temperature: ‑20 °C to +60 °C.

• Storage temperature: ‑40 °C to +85 °C.

• Humidity: 0–95% RH, non‑condensing.

• Protection class: IP20 (cabinet mounting).

• Mounting: Shark XL / 45C‑series DIN rail.

• Certification: UL/CUL, CE, CSA, FCC.

• Lifespan: >50,000 hours under rated conditions.

Interface and Communication Configuration

• Backplane connection: Plug‑in to Shark XL rack backplane for DC power distribution.

• AC input: Screw terminals for line, neutral, ground.

• Communication: No external communication ports; power‑only module.

• Compatibility: Shark XL series racks; works with 45C‑series I/O modules.

Core Functions

• Converts 115/230 VAC line power into stable DC for the PLC backplane and I/O modules.

• Provides galvanic isolation between AC line and control circuits to suppress noise and enhance safety.

• Built‑in overvoltage, overcurrent, short‑circuit, and thermal protection safeguards the system.

• LED status enables real‑time monitoring of power health and fault conditions.

• Supports hot‑swap replacement (with system power removed) for minimal downtime.

Application Scenarios

• Industrial automation: Powering Shark XL PLC racks and 45C‑series I/O modules in manufacturing, process control, and material handling.

• Panel building: Standard power supply for OEM control panels requiring 115/230 VAC input and isolated DC distribution.

• Harsh environments: Suitable for factory floors with wide temperature fluctuations and electrical noise.

Operation and Maintenance Instructions

• Install on a Shark XL DIN rail and ensure full backplane engagement before wiring.

• Set the input voltage jumper to 115 VAC or 230 VAC per local line voltage.

• Torque AC input terminals to manufacturer specs; verify proper grounding.

• During operation, monitor LEDs: Power OK ON, fault LED OFF for normal status.

• Keep the module clean and well‑ventilated to prevent overheating.

• Disconnect AC power before removal, inspection, or replacement.

• Do not disassemble internal components; replace the entire module if a permanent fault occurs.

• The unit is discontinued by Reliance Electric; use surplus or refurbished units for replacement.